Publicité
Les langues disponibles
Les langues disponibles
Configuring the Switch Using the Console Port
Step 1: Connect a computer to the switch's console port using the console cable.
Step 2: Start the terminal simulation software such as HyperTerminal on the computer.
Step 3: Set the parameters of the HyperTerminal: 9600 bits per second, 8 data bits, no parity, 1 stop
bit and no flow control.
Quick Connect
Protocol:
The port may be manually entered or selected from the list.
Port:
Baud rate:
Data bits:
Parity:
Stop bits:
Name of pipe:
Show quick connect on startup
Step 4: After setting the parameters, click Connect to enter.
Troubleshooting
Serial port console has no output or outputs illegible characters
1. Change the serial port opened by the configuration software to be the one connected to the switch.
2. Check that the parameter configuration of the serial port matches that specified in the instructions.
1/10G Port is not Working
In the case of compatible cables and transceivers, the port cannot be up, please try to modify the port
mode to adapt or force the port speed to 1/10G.
Connecting the Switch Remotely Unsuccessfully
1. Test network connectivity through ping.
2. If the network is reachable, try restarting the switch.
3. Check if the corresponding service is enabled.
Serial
COM3
9600
Flow Control
DTR/DSR
8
RTS/CTS
None
XON/XOFF
1
Save session
Open in a tab
Connect
Cancel
x
17
Publicité
