Briteq BEAM WIZARD5x5 Mode D'emploi page 6

ENGLISH
5. DMX OUT: both 3pin and 5pin outputs are available to daisy chain the projector with other units that will
be controlled by a DMX-controller. While Art-Net is used, the DMX-outputs will carry the complete DMX-
universe you selected. (Art-Net node functionality).
6. ETHERNET IN/OUT: used to connect the projector to an Ethernet network, Art-Net protocol is supported.
7. [MENU] buttons: used to browse the different options of the setup menu.
 MENU/ESC. Button: has several functions:
 Enter the SETUP-menu: press shortly.
 Enter the SETUP-menu while the display lock function is active: press during 3s.
 Go 1 level up in the SETUP-menu: press shortly to go 1 level up.
 Leave the SETUP-menu: press several times until the standard display is shown.
 ◄/►Buttons: mainly used to navigate in the SETUP-menu. The ►button is also used to rotate the
display over 180° (upsidedown).
 ▲/▼Buttons: mainly used to change the values of the selected function.
 [ENTER]-button: used to confirm the current action.
8. DISPLAY: the backlit matrix LCD-display shows important information like:
channel mode, DMX-start/end address, IP-address, DMX-universe. The
backlight is lit soon as one of the buttons is pressed. The display blinks while the
DMX or Art-Net signal is lost.
9. BATTERY OPERATION Button: thanks to the internal battery you can browse
the SETUP-menu and change settings while the projector is disconnected from the mains.
10. MOUNTING BASE: the strong metal base is designed to be used with 2pcs "OMEGA BRACKET BIG"
(included) and an optional safety cable.
11. PAN/TILT LOCKING: used to lock the PAN/TILT movements during transport.
IMPORTANT: make sure to UNLOCK these handles before you switch the projector on!
12. COOLING FANS: during its operation the projector produces heat that must be dissipated. The fans
inside the projector must be able to evacuate the heat in the most effective way. Therefore is it very
important not to cover any of the ventilation openings as this may result in overheating.
OVERHEAD RIGGING
Important: The installation must be carried out by qualified service personal only. Improper
installation can result in serious injuries and/or damage to property. Overhead rigging requires
extensive experience! Working load limits should be respected, certified installation materials should
be used, the installed device should be inspected regularly for safety.
 Make sure the area below the installation place is free from
unwanted persons during rigging, de-rigging and servicing.
 Locate the fixture in a well ventilated spot, far away from any
flammable materials and/or liquids. The fixture must be fixed at
least 50cm from surrounding walls.
 The device should be installed out of reach of people and outside
areas where persons may walk by or be seated.
 Before rigging make sure that the installation area can hold a
minimum point load of 10times the device's weight.
 Always use a certified safety cable that can hold 12times the
weight of the device when installing the unit. This secondary safety
attachment should be installed in a way that no part of the
installation can drop more than 20cm if the main attachment fails.
 The device should be well fixed; a free-swinging mounting is
dangerous and may not be considered!
 Don't cover any ventilation openings as this may result in
overheating.
 The operator has to make sure that the safety-relating and
machine-technical installations are approved by an expert before
using them for the first time. The installations should be inspected
every year by a skilled person to be sure that safety is still optimal.
BRITEQ
®
4/107 BEAM WIZARD5x5-RGBW
OPERATION MANUAL