Briteq BEAM WIZARD5x5 Mode D'emploi page 12

ENGLISH
[SET CONFIG > FAN Set] –
On some occasions fan noise should be reduced to a minimum. Therefore you can set three different
fan speed modes.
 Press the ▲/▼/◄/► buttons until the desired function is showing on the display.
 Press the [ENTER] button: the values can be changed
 Use ▲/▼ buttons to select one of these options:
 [Auto]: the fan speed will be automatically adjusted to always have the best balance between fan
noise and performance (light output).
 [Low]: the fan speed will always be low to reduce fan noise to a minimum. (use in theatres,
conference rooms, ...). However this means that the LED temperature could become too high: in that
case the LED current will be reduced automatically to protect the LED. Light output will also be lower.
 [High]: the LED will be well cooled so maximum light output can be guaranteed under all conditions.
However this means that fan noise will be higher than usual. While used in discotheques and in hot
summertime conditions this should not be a problem.
 Press the [ENTER] button to confirm.
[SET CONFIG > DISPLAY Set] –
This level contains all display related settings.
[Backlight]
Used to adjust how long the display stays lit after the last time it was used.
 Press the ▲/▼/◄/► buttons until the desired function is showing on the display.
 Press the [ENTER] button: the values can be changed
 Use ▲/▼ buttons to select one of these options:
 [ON]: display is always lit.
 [0xxM]: you can set the number of minutes before the display turns dark after it was last used.
 Press the [ENTER] button to confirm.
[Flip 180]
Used to turn the display over 180°: [ON] = display is upsidedown.
 Press the ▲/▼/◄/► buttons until the desired function is showing on the display.
 Press the [ENTER] button: the values can be changed
 Use ▲/▼ buttons to toggle between ON and OFF.
 Press the [ENTER] button to confirm.
[AUTO LOCK]
Used to lock the setup menu against unwanted altering of the settings.
 Press the ▲/▼/◄/► buttons until the desired function is showing on the display.
 Press the [ENTER] button: the values can be changed
 Use ▲/▼ buttons to toggle between ON and OFF.
 Press the [ENTER] button to confirm.
Remark: while the display is locked you have to press the [MENU]-button for 3s to enter the setup menu.
[noDMX blink]
Used to select of the display should blink or not when the DMX/Art-Net signal was lost.
 Press the ▲/▼/◄/► buttons until the desired function is showing on the display.
 Press the [ENTER] button: the values can be changed
 Use ▲/▼ buttons to toggle between ON and OFF.
 Press the [ENTER] button to confirm.
[Temp C/F]
Used to select if the LED-temperature is shown in degrees Celcius [°C] or Fahrenheit [°F].
 Press the ▲/▼/◄/► buttons until the desired function is showing on the display.
 Press the [ENTER] button: the values can be changed
 Use ▲/▼ buttons to select one of these options:
 [Celcius]: LED-temperature is shown in degrees Celcius [°C].
 [Fahrenheit]: LED-temperature is shown in degrees Fahrenheit [°F].
 Press the [ENTER] button to confirm.
BRITEQ
®
10/107
OPERATION MANUAL
BEAM WIZARD5x5-RGBW