Briteq BEAM WIZARD5x5 Mode D'emploi page 14

ENGLISH
[INFORMATION > LED Temp.] –
Shows the actual temperature of the LEDs.
 Press the ▲/▼/◄/► buttons until the desired function is showing on the display.
 Press the [ENTER] button: the LED temperature is shown.
[INFORMATION > ERROR info] –
Shows information about eventual errors.
 Press the ▲/▼/◄/► buttons until the desired function is showing on the display.
 Press the [ENTER] button:
 No errors: display shows [NONE]
 Errors to report: the error will be shown on the display so you can take action.
[INFORMATION > DMX values] –
Shows the function and DMX-value for the last used DMX channel: used for problem solving
 Press the ▲/▼/◄/► buttons until the desired function is showing on the display.
 Press the [ENTER] button: the display shows the function and DMX-value of the last used channel.
 Use a DMX-controller to control the projector: every time a value on one of the DMX-channels was
changed, the information will be shown on the display.
[INFORMATION > Model Name] –
Shows the name of the projector.
 Press the ▲/▼/◄/► buttons until the desired function is showing on the display.
 Press the [ENTER] button: the display shows [BEAMWIZARD5x5].
[INFORMATION > Firmware V.] –
Shows the current firmware version in the projector.
 Press the ▲/▼/◄/► buttons until the desired function is showing on the display.
 Press the [ENTER] button: the display shows the firmware versions of the different processors in the
projector: 1U01, 2U01, 3U01, 4U01
Note: The firmware of this unit can be upgraded using a special upgrade tool with Windows
(separately available from Briteq). More information about this can be found in the user manual of the
upgrade tool and / or our website: www.briteq-lighting.com
[TEST/RESET > AUTO TEST] –
Used to start the automatic test function: all functions will be tested.
 Important: use the projector in STANDALONE (NO DMX or Ethernet connection)
 Press the ▲/▼/◄/► buttons until the desired function is showing on the display.
 Press the [ENTER] button: the projector starts an automatic AUTOTEST program until you stop it.
 Press the [MENU] button to stop the program.
[TEST/RESET > RESET Menu ] –
Used to reset certain functions of the projector.
 Press the ▲/▼/◄/► buttons until the desired function is showing on the display.
 Press the [ENTER] button: the display shows [PAN/TILT] (the only option, no other functions to reset)
 Press the [ENTER] button again to start resetting.
BRITEQ
®
12/107
OPERATION MANUAL
BEAM WIZARD5x5-RGBW
®
software.