Human Touch HT-Reflex 2 Manuel D'utilisation Et D'entretien page 4

get ready
humantouch.com
1. Plug it in
Plug the power cord into an appropriate power source.
2. Power on
Turn the master power switch (on the rear lower right-hand corner of the massager) to On.
3. Position your foot and calf massager in front of your favorite chair.
4
4. Take a seat.
5. Place your feet all the way into
the massage wells.
foot and calf
NOTE: Follow the below steps to remove your feet from the unit in
the event of a power failure:
1. Lift your knees upward (Fig. 1).
2. Rotate your feet sideways and ease them out (Fig. 2).
Sitting or standing on your foot and calf massager could result in personal injury and or permanent damage to the massager.
Your foot and calf massager comes fully
assembled. Simply plug it in, take a seat and
you're set to go!
Fig. 1 Fig. 2
5