• Do not use during an electrical storm or in windy conditions.
• Do not use near gasoline or other flammable liquids, gases, or where flammable vapors may
be present.
• Place in an area where children and pets cannot access.
• Do not immerse in water.
• Empty drip bowl every 2 to 3 hours of burnt wood bisquettes and refill with fresh water.
• Unplug smoker when it is not in use. See Maintenance Procedures.
• Place extinguished Bradley Flavor Bisquettes® at a safe distance from all structures and
combustible materials.
• Store the smoker in a dry covered place out of reach of children.
• Clean out any grease. Grease build up may cause fire.
Refer to the External Components List & Internal Components List Diagrams
• The Bradley Smoker must be maintained and cleaned after each use.
• Unplug the Long Power Cord prior to commencement of any maintenance or cleaning.
• Do not immerse smoker in water.
• Do not spray inside of smoker with any kind of appliance cleaner.
• Do not cover or seal the racks or drip tray with aluminum foil. This can cause severe
damage to your smoker.
• Do not leave unattended when in use.
• Do not spray or clean the smoker with excessive amounts of water. Instead use a damp cloth.
• Use caution when handling and cleaning your smoker as some metal edges may be sharp.
• Clean out the Drip Bowl. Dispose of all burnt Bisquettes carefully as they may still be hot.
• Wash the Drip Tray, Racks, Bottom Rectangular Tray and Drip Bowl with hot water and
dish detergent or put them in the dishwasher.
• Remove food particles and grease residue from the smoker. If the inside needs cleaning,
wipe it with a damp cloth.
Note: The tower should have smoke or black residue on the inside. The more residue, the better the
product will taste.
• The Smoke Generator should be kept clean and free of wood chips and grease at all times.
If loose wood chips have collected in the Smoke Generator, simply blow or vacuum these
particles away. Unplug the Long Power Cord before removing the Smoke Generator from
the Smoke Tower. Refer to "Remove Smoke Generator" in "Assembly Instructions".
• The Bisquette Burner should be lightly scraped using a wire brush or scraper to remove any
residue that has been left by the burning process.
• Clean the Damper (at the top of the Smoker) to ensure it is not stuck.
• Wipe the Door Seal with warm water and dish detergent to remove any leftover residues
and food particles.
• Replace Racks, Drip Tray, Bottom Rectangular Tray and Drip Bowl into the smoker,
making sure all parts are clean and dry.
• Insert the Smoke Generator back into the Smoke Tower.
• Make sure the Long Power Cord is unplugged.
When in Use
After Each Use
Save these Instructions
General Maintenance
Important Safety Precautions
Maintenance Procedures
After Cleaning
3
(cont.)