Bradley Smoker BTIS1 Manuel Du Propriétaire page 10

The Original Bradley Smoker (Model: BS611; BS611EU)
For The Black Black Smoker See Page 5 For 4 and 6 Rack Digital Smokers See Page 13
Refer to Part Numbers in External Components List, Internal Components List and Electrical
How to Assemble The
Original Bradley Smoker®
1. Remove smoker from box.
2. Take all packaged parts out of
smoker.
3. Remove all protective packaging
materials from parts.
Install Smoke Dial Generator:
Attach smoke dial generator (1)
•
to the smoker tower (2).
Aim the bisquette burner (F)
•
toward the tower opening.
Align smoke dial generator key
•
holes to smoker tower locating
supports (3).
Secure the smoke dial generator
•
by pushing down firmly.
Insert the feeder tube (4) on top
•
of the smoke dial generator and
push down firmly then load it with
the desired number of Bradley
Flavor Bisquettes®.
Plug the short power cord (E-not
•
shown) from the smoke dial
generator into the smoker tower.
Set Up Smoker Tower:
Place Racks (C) onto side
•
supports.
Place Drip Tray (B) "V" facing
•
down beneath the Racks on the
brass side pins.
Assembly Instructions
Connection Set Up
•
the bottom of the Smoker.
•
of water and place in the center
of the Rectangular Tray to catch
burnt Bisquettes. During a long
smoking period, the Drip Bowl
will require changing the water
every 2-3 hours.
•
for the smoke generator into an
approved grounded electrical
outlet.
To Remove Smoke Dial Generator:
•
•
from the smoker tower by raising
the smoke dial generator gently
upward and pull it outward.
All packaging should be discarded
as per the regulations in your area.
The box can be used only to store
smoker when not in use. The box
should not be used as a cover when
smoker is in use.
9
Place the Rectangular Tray (J) on
Fill the Drip Bowl (D) half full
Plug the Long Power Cord (A)
Unplug short jumper cord (E).
Detach smoke dial generator
Handling of Packaging