Avery Dennison FRESHMARX 9415 Guide De Référence Rapide page 10

L o a d i n g L a b e l s
Printer 1 is the default printer.
1. Turn on the printer. Press the power switch on the side of the
printer to the on (I) position.
2. Remove and discard the tape from a new roll of labels.
3. Lower the supply door.
4. Slide a roll of labels onto the supply holder.
If necessary, adjust the supply holder guide so it touches the
roll.
5. Feed the labels, printing side up, into the supply slots in the
supply door.
Note: Make sure no label adhesive is exposed when loading
labels. This causes jams.
6. Make sure the supply clip is in the correct position to touch the
edge of the supply. This clip guides the labels through the
supply slot so they do not shift while printing.
7. Close the supply door.
8. The printer calibrates the labels automatically.
4
Supply clip
Supply slot
Supply Holder
Guide
Printer 2
Printer 1