Troubleshooting; Maintenance - Delta 46-715 Manuel D'utilisation

8. Fig. 69 illustrates the rough cutting of the inside of a bowl.
9. Outboard turning is illustrated in Fig. 70. Note that the headstock (A) is turned 45 degrees and the tool rest auxiliary extension
(B) is attached. Outboard turning generally is used for larger workpieces, but smaller work can be accomplished using this
technique.
For assistance with your machine, visit our website at www.deltaportercable.com for a list of service centers or call the DELTA
Machinery help line at 1-800-223-7278 (In Canada call 1-800-463-3582).
KEEP MACHINE CLEAN
Periodically blow out all air passages with dry compressed
air. All plastic parts should be cleaned with a soft damp cloth.
NEVER use solvents to clean plastic parts. They could possibly
dissolve or otherwise damage the material.
Wear ANSI Z87.1 safety glasses while using
compressed air.
FAILURE TO START
Should your machine fail to start, check to make sure the prongs
on the cord plug are making good contact in the outlet. Also,
check for blown fuses or open circuit breakers in the line.
Fig. 69

TROUBLESHOOTING

MAINTENANCE

LUBRICATION
Occasionally, apply lightweight oil or silicone spray to the pulley
(P) Fig. 70A. Apply household floor paste wax to the lathe bed
surface weekly.
PROTECTING CAST IRON FROM RUST
To clean and protect machined cast iron surfaces from rust, you
will need the following materials: 1 pushblock from a jointer, 1
sheet of medium Scotch-Brite™ Blending Hand Pad, 1 can of
WD-40 ® , 1 can of degreaser, 1 can of TopCote ® Aerosol. Apply
the WD-40 and polish the table surface with the Scotch-Brite
pad using the pushblock as a holddown. Degrease the table,
then apply the TopCote ® accordingly.
18
B
Fig. 70
Fig. 70A
A
P