Extension Cords; Functional Description; Carton Contents; Unpacking And Cleaning - Delta 46-715 Manuel D'utilisation

EXTENSION CORDS

Use proper extension cords. Make
sure your extension cord is in good condition and is a
3-wire extension cord which has a 3-prong grounding
type plug and matching receptacle which will accept
the machine's plug. When using an extension cord,
be sure to use one heavy enough to carry the current
of the machine. An undersized cord will cause a
drop in line voltage, resulting in loss of power and
overheating. Fig. D-1 or D-2, shows the correct gauge
to use depending on the cord length. If in doubt,
use the next heavier gauge. The smaller the gauge
number, the heavier the cord.
FOREWORD
The Delta 46-715 14" adjustable speed wood lathe is a big capacity lathe, designed for industry, commercial shops, and schools.
NOTICE: The manual cover illustrates the current production model. All other illustrations contained in the manual are
representative only and may not depict the actual labeling or accessories included. These are intended to illustrate
technique only.
1
8
7
1. Headstock Assembly
2. Tool Rest Assembly
3. Tailstock Assembly
4. Lathe Bed
5. Leg (4)
6. Short Tie Bar (2)
7. Stand Top (2)
8. Long Tie Bar (2)
9. Knockout Bar

UNPACKING AND CLEANING

Carefully unpack the machine and all loose items from the shipping container(s). Remove the rust-preventative oil from
unpainted surfaces using a soft cloth moistened with mineral spirits, paint thinner or denatured alcohol.
Do not use highly volatile solvents such as gasoline, naphtha, acetone or lacquer thinner for cleaning your
machine.
After cleaning, cover the unpainted surfaces with a good quality household floor paste wax.

FUNCTIONAL DESCRIPTION

CARTON CONTENTS

3
2
4
5 6
MINIMUM GAUGE EXTENSION CORD
RECOMMENDED SIZES FOR USE WITH STATIONARY ELECTRIC MACHINES
Length of
Ampere
Cord in
Rating Volts
0-6 120 up to 25
0-6 120 25-50
0-6 120 50-100
0-6 120 100-150
6-10 120 up to 25
6-10 120 25-50
6-10 120 50-100
6-10 120 100-150
10-12 120 up to 25
10-12 120 25-50
10-12 120 50-100
10-12 120 100-150
12-16 120 up to 25
12-16 120 25-50
12-16 120
GREATER THAN 50 FEET NOT RECOMMENDED
16
15
17
10. Spindle Wrench
11. Live Center
12. M8 x 16mm Carriage Bolts (24)
13. Nuts (32)
14. Flat Washers (32)
15. Lockwashers (32)
16. M8 x 35mm Hex Head Screws (8)
17. Drive Center
6
Total
Gauge of Extension
Feet Cord
18 AWG
16 AWG
16 AWG
14 AWG
18 AWG
16 AWG
14 AWG
12 AWG
16 AWG
16 AWG
14 AWG
12 AWG
14 AWG
12 AWG
Fig. D-1
9 10
14 13 12
11