Troubleshooting; Maintenance - Delta 46-455 Manuel D'instructions

TURNING IN REVERSE (46-460 ONLY)
®
FOR THE DELTA MODEL 46-460 MIDI-
LATHE ONLY: To reduce the risk of injury, be sure
to only use accessories equipped with locking set
screws for turning the lathe in reverse. Also, do not
switch lathe turning directions until the workpiece
comes to a complete stop.
Care should be taken not to stall the
workpiece when turning in reverse. If a stall should
occur, stop the lathe and verify that the chuck or
MM
faceplate is fully seated and both set screws are
tight before continuing.
Fig. 28
NOTE:

TROUBLESHOOTING

®

MAINTENANCE

To reduce the risk of injury, turn unit off and disconnect it from power source before installing and removing
accessories, before adjusting or when making repairs.
KEEP MACHINE CLEAN
To reduce the risk of injury, wear certified safety equipment for eye, hearing and respiratory protection
while using compressed air.
FAILURE TO START
LUBRICATION & RUST PROTECTION