Assembly - Delta 46-715 Manuel D'utilisation

For your own safety, do not connect the machine to the power source until the machine is
completely assembled and you read and understand the entire instruction manual.
Assembly for this tool will require a phillips-head screwdriver and an adjustable wrench.
ASSEMBLING THE STAND
1. Attach the two long tie bars (A) Fig. 3 (with the flanges
up) to the center of each stand leg (B) by using eight
carriage bolts through the legs and tie bars, secured by
flat washers, lockwashers, and hex nuts.
NOTE: Hand-tighten the hardware for further adjustment.
2. Attach two short tie bars (C) Fig. 3 (with the flanges up),
to each leg (B), using eight carriage bolts through the legs
and tie bars, secured by flat washers, lock-washers, and
hex nuts.
3. Attach the two stand tops (D) Fig. 3 to the inside of the
top of the stand legs (B) using twelve carriage bolts
through the leg, then through the stand top. Secure with
flat washers, lockwashers, and hex nuts.
ATTACHING THE LATHE BED TO THE STAND
The 46-715 lathe comes attached to plyboard. To attach
the lathe bed to the stand:
1. Remove the security bars (A) Fig. 4 that are attached
to both ends of the lathe bed by removing the two
screws (B) Fig. 4 that secure it.
2. The headstock is very heavy. Have
someone help remove it from the lathe bed.
3. Loosen the lock handle (C) Fig. 5 and slide the
headstock off the end of the lathe bed.
4. Loosen the lock handle (D) Fig. 6 and slide the tool
rest off the end of the lathe bed.
5. Loosen the lock handle (E) Fig. 7 and slide the
tailstock off the end of the lathe bed.
6. Remove the two bolts (one is shown at (F) Fig. 8) to
free the lathe bed from the plyboard.
7. The lathe bed is heavy. Have someone
help lift it on the stand.
8. Position the lathe bed so that the holes in the lathe
bed are directly above the holes in the stand.
9. Secure the lathe bed to the stand using the eight
M8 x 35mm Hex head screws (G) Fig. 9 through the
lathe bed and through the stand. Attach a washer,
lockwasher, and nut and tighten securely.
10. Before tightening all hardware, press down on stand
until legs adjust to floor surface. Securely tighten all
hardware.
11. Slide the tool rest and tailstock back into the lathe
bed.
12. Have someone help lift the headstock on the lathe
bed and slide it into position.

ASSEMBLY

ASSEMBLY TOOLS REQUIRED
ASSEMBLY TIME ESTIMATE
Assembly for this tool should take approximately 1 to 2 hours.
B
A
B
Fig. 4
Fig. 6
F
Fig. 8
7
D
B
C
A
Fig. 3
Fig. 5
E
D
Fig. 7
G
Fig. 9
C