Replacing Drive Belt; Service; Replacement Parts; Free Warning Label Replacement - Delta 46-715 Manuel D'utilisation

REPLACING DRIVE BELT

1. Remove the four screws (A) Fig. 71 (three of which are
shown) to take the back off of the headstock.
2. Use a #5 Allen wrench to remove the three screws (A) Fig.
72. Slide the spindle handle out. Pull the spindle lock to
the out position (see Fig. 24A).
3. Remove the belt (A) Fig. 73 from the pulley (B).
NOTE: When pulling the belt out or replacing the belt, pull the
spindle lock handle (B) Fig. 72 out to its fullest position to give
more room (C) Fig. 73 for belt removal or replacement.
4. Replace new belt by using these instructions in reverse
order.
A
Fig. 72

REPLACEMENT PARTS

Use only identical replacement parts. For a parts list or to order parts, visit our website at servicenet.deltaportercable.com.
You can also order parts from your nearest factory-owned branch, or by calling our Customer Care Center at 1-800-223-7278 to
receive personalized support from highly-trained technicians.

FREE WARNING LABEL REPLACEMENT

If your warning labels become illegible or are missing, call 1-800-223-7278 for a free replacement.

SERVICE AND REPAIRS

All quality tools will eventually require servicing and/or replacement of parts. For information about Delta Machinery, its factory-
owned branches, or an Authorized Warranty Service Center, visit our website at www.deltaportercable.com or call our Customer
Care Center at 1-800-223-7278. All repairs made by our service centers are fully guaranteed against defective material and
workmanship. We cannot guarantee repairs made or attempted by others.
You can also write to us for information at Delta Machinery, 4825 Highway 45 North, Jackson, Tennessee 38305 - Attention:
Product Service. Be sure to include all of the information shown on the nameplate of your tool (model number, type, serial number,
etc.)
B

SERVICE

19
A
A
C
B
Fig. 73
Fig. 71