Eliminating Minor Faults Yourself - Bosch KIN Série Mode D'emploi

en

Eliminating minor faults yourself

Before you call customer service:
Please check whether you can eliminate the fault yourself based on the following
information.
Customer service will charge you for advice – even if the appliance is still under
guarantee!
Fault
Temperature differs greatly
from the set value.
Bottom of the refrigerator
compartment is wet.
The temperature in
the refrigerator
compartment is too cold.
The refrigerating unit
is switching on more
frequently and for longer.
Appliance has no
refrigeration capacity.
The light does not work.
The display does not
illuminate.
Appliance is not cooling,
temperature display and light
are lit.
42
Possible cause
The condensation channel
or drainage hole are blocked.
Temperature has been set
too low.
Appliance opened
frequently.
The ventilation openings
have been covered.
Appliance has been switched
off.
Power failure.
The fuse has been switched
off.
The mains plug has not been
inserted properly.
Showroom mode is
switched on.
Remedial action
In some cases it is adequate to switch off
the appliance for 5 minutes.
If the temperature is too high wait a few hours
and check whether the temperature has
approached the set value.
If the temperature is too low check
the temperature again the next day.
Clean the condensation channel
and the drainage hole. See chapter Cleaning
the appliance. Fig. )
Increase the temperature.
Do not open the appliance unnecessarily.
Remove obstacles.
Press the On/Off button.
Check whether the power is on.
Check the fuse.
Check whether the mains plug is secure.
Hold down alarm button, Fig "/1, for
10 seconds until an acknowledgement signal
sounds.
After a short time check whether your
appliance is cooling.