Scheppach AB1600 Traduction Des Instructions D'origine page 45

• Check the machine before use for
damaged parts and determine whether
these parts work properly and perform
its intended function; in case of doubt,
the part is to be replaced.
• Check the alignment of all moving
parts, broken or mounting parts, and
other conditions that could impair prop-
er operation. Any damaged part should
be repaired or replaced by a qualified
technician.
• Do not use the machine if a switch can-
not be switched on and off correctly.
m CAUTION! Before beginning the op-
eration, check the installation site for con-
cealed electrical cables, gas and water
pipes using a pipe locator.
9. Work instructions
• Use only proper equipment.
• Make all machine adjustments only with
the machine switched off.
• Never leave the machine unattended
while it is running.
• When switching off, leave the machine
only after it comes to a complete stand-
still.
• Turn the machine off before you unplug
it.
• Always unplug the mains cord. Never
pull out the plug from the wall outlet by
holding the cable.
• Perform maintenance and cleaning of
the device regularly.
10. Getting started
Using the chisel (Fig. B)
1. Clean chisel always before inserting it
and lubricate the shaft slightly.
2. Pull out the locking bolts (6) up to the
end stop, turn by 180° and release.
3. Insert chisel into the tool holder (5)
and slide it up to the end stop.
4. Pull out the locking bolts (6) once
again, turn by 180° and release.
5. Check lock on the tool.
Remove chisel
Pull out the locking bolts (6) up to the end
stop, turn by
180° and release, and remove the chisel.
Additional handle (Fig. C)
For safety reasons, use the demolition
hammer only with the additional han-
dle!
1. The additional handle (4) provides you
safe grip while using the demolition
hammer.
2. The additional handle (4) can be rotat-
ed to any position.
3. Loosen the screw (a).
4. Turn the additional handle (4) to a con-
venient and safe working position and
tighten the screw (a) again.
Switching on / off (Fig. D)
Switching on: Press the operating switch
(3).
Switching off: Release the operating
switch (3).
www.scheppach.com
GB | 45