Denon AVR-2106 Mode D'emploi page 44

ENGLISH
Advanced Setup – Part 2
This Speaker Setup section describes the procedures to make
speaker settings manually (without using the Auto Setup
function), as well as to make manual changes to settings that
have already been made by the Auto Setup function.
Speaker Setup
Setting the Speaker Config.
The composition of the signals output to each channel and the
frequency response are adjusted automatically according to the
combination of speakers actually being used.
1
CURSOR D D
Press the or
"Speaker Setup" at the "System Setup" menu,
ENTER
then press the button.
• The "Speaker Setup" screen appears.
2 CURSOR D D
Press the or
"Speaker Config.", then press the
button.
• The "Speaker Config." screen appears.
3
Press the
speaker, then press the
to select a parameter.
H H
button to select
4
Press the
• The "Speaker Setup" menu appears.
H H
button to select
• Select "Large" or "Small" not according to the actual size of
ENTER the speaker but according to the speaker's capacity for playing
low frequency (bass sound below the frequency set for the
Crossover Frequency) signals. If you are unsure, try comparing
the sound at both settings (setting the volume to a level low
enough so as not to damage the speakers) to determine the
proper setting.
ENTER
CURSOR
CURSOR D D H H
or button to select a
CURSOR F F G G
or button
Center Sp.
Front Sp.
Subwoofer
Surround Sp.
Surround back Sp.
ENTER
button to enter the setting.
41
ENGLISH
Advanced Setup – Part 2
2 Parameters
Large:
Select this when using speakers that have sufficient ability to
reproduce bass sound below the frequency set for the
crossover frequency mode.
Small:
Select this when using speakers that do not have sufficient
ability to reproduce bass sound below the frequency set for the
crossover frequency mode. When this is set, bass sound with
a frequency below the frequency set for the crossover
frequency mode is sent to the subwoofer.
None:
Select this when no speakers are installed.
Yes / No:
Select "Yes" when a subwoofer is installed, "No" when a
subwoofer is not installed.
2sp / 1sp:
Set the number of speakers to be used for the surround back
channel.
If the subwoofer has sufficient low frequency playback
capacity, good sound can be achieved even when "Small" is
set for the front, center and surround speakers.
Setting the Delay Time
Input the distance between the listening position and each
speaker to set the delay time for the surround playback.
Preparations:
Measure the distances between the listening position and the
speakers.
FL Center FR
Subwoofer
Listening position
SL
SBL SBR
SR