Denon AVR-2106 Mode D'emploi page 26

ENGLISH
Basic Operation
FUNCTION INPUT MODE
STANDARD/NIGHT
2 Checking the input signal
The input signal can be checked by pressing the remote control
unit's ON SCREEN button.
SIGNAL:
Displays the type of signal (DTS, DOLBY DIGITAL, PCM, etc.).
fs:
Displays the input signal's sampling frequency.
FORMAT:
Displays the input signal's number of channels.
"Number of front channels/Number of surround channels/ LFE
on/off".
"SURROUND" is displayed for 2-channel signal sources
recorded in Dolby Surround.
OFFSET:
Displays the dialog normalization offset value.
FLAG:
Displays the special identification signal recorded in the input
signal.
"MATRIX" is displayed when matrix processing is conducted
on the surround back channel, "DISCRETE" is displayed when
discrete processing is conducted.
Not displayed if an identification signal has not been recorded.
STANDARD
FUNCTION
ENTER
CURSOR
ON SCREEN
INPUT MODE
• In addition, screen information is displayed in the following
order when the ON SCREEN button is pressed repeatedly:
OSD-1 Input signal
OSD-2 Input/output
OSD-3 Auto surround mode
OSD-4~10 Tuner preset stations
NOTE:
• OSD-3:
This is displayed when the auto surround mode is set to
"ON" and the input mode is set to "Auto".
It is not displayed when the input mode is set to "Analog"
or "EXT. IN".
23
ENGLISH
2 Dialog normalization
The dialog normalization function is activated automatically when
playing Dolby Digital program sources.
Dialog normalization is a basic function of Dolby Digital which
automatically normalizes the dialog level (standard level) of the
signals which are recorded at different levels for different
program sources, such as DVD, DTV and other future formats
that will use Dolby Digital.
These contents can be verified with the ON SCREEN button.
Display
OFFSET - 4dB
The number indicates the normalization level when the
currently playing program is normalized to the standard level.
Night mode
When listening at night or at lower volumes, the night mode
improves listenability.
STANDARD/NIGHT
Press and hold the
several seconds to enter the night mode.
• Canceling night mode:
Press and hold the STANDARD/NIGHT button again.
• The night mode only works when playing program sources
recorded in Dolby Digital or DTS.
Adjusting the audio delay
• When watching a DVD or other video source, the picture on the
monitor may seem delayed with respect to the sound. In this
case, adjust the audio delay to delay the sound and synchronize
it with the picture.
• The audio delay setting is stored separately for each input
source.
• This adjustment can be performed with the system setup
( page 38) or from the remote control unit, as described
below.
Basic Operation
button for