Press 2Y.
1
Press 12 to select [Y ON], and press o.
2
3
Press the shutter button fully to take the picture.
The self-timer lamp lights for approximately 10 seconds
after the shutter button is pressed, then starts blinking.
After blinking for approximately 2 seconds, the picture
is taken.
Press 3#.
1
Press 12 to select the flash mode, and press o.
2
3
Press the shutter button halfway.
When the flash is set to fire, the # mark lights.
4
Press the shutter button completely to take the picture.
Flash working range:
W (max.): 0.2m~4.0m (0.6 ft. to 13.1 ft.)
T (max.): 0.5m~2.4m (1.6 ft. to 7.8 ft.)
Icon
Flash Mode
No
Auto flash
indication
Red-eye
!
reduction flash
#
Fill-in flash
$
Flash off
Power Save Feature
To save battery power, the camera automatically enters sleep mode and stops
operating if not used for 3 minutes in shooting mode. Press the shutter button or
zoom button to reactivate the camera.
If the camera is not operated for 15 minutes after the camera enters sleep mode,
it automatically retracts the lens and turns off. To resume operation, turn on the
power again.
Self-Timer
Flash Modes
The flash fires automatically in low light or backlight
conditions.
The red-eye reduction flash mode significantly reduces this
phenomenon by emitting pre-flashes before firing the
regular flash.
The flash fires regardless of the available light.
The flash does not fire even in low light conditions.
Self-Timer Lamp
Description
En
13