1
Press rY.
2
Press sr to select [Y12 SEC] or [Y2 SEC],
and press o.
3
Press the shutter button completely to take the
picture.
Y12 SEC: The self-timer lamp lights for approximately
10 seconds, then starts blinking.
After blinking for approximately 2 seconds, the
picture is taken.
Y2 SEC: The self-timer lamp blinks for 2 seconds, then
the picture is taken.
Flash Modes
1
Press #(Flash pop-up) to open the flash.
Press sr to select the flash mode, and press o.
2
3
Press the shutter button halfway.
When the flash is set to fire, the # mark lights.
4
Press the shutter button completely to take the picture.
Icon
Flash Mode
Auto flash
AUTO
Red-eye
!
reduction flash
#
Fill-in flash
Red-eye fill-in
! #
flash
# SLOW Slow flash
$
Flash off
Power Save Feature
To save battery power, the camera automatically enters sleep mode and stops
operating if not used for 3 minutes in shooting mode. Press the shutter button
or turn the zoom lever to reactivate the camera.
If the camera is not operated for 4 hours after the camera enters sleep mode, it
automatically retracts the lens and turns off. To resume operation, turn on the
power again.
Self-Timer
The flash fires automatically in low light or backlight
condition.
Emits pre-flashes for red-eye reduction.
The flash fires regardless of the available light.
The flash always fires after pre-flashes for red-eye
reduction are emitted.
The flash fires with slow speed.
The flash does not fire even in low light conditions.
Self-Timer Lamp
Description
En
13