Tecnoinox PBP Notice D'emploi Et De Maintenance page 10

Do not wash the appliance with water jets, as water might reach the
electric components, resulting in faulty operation and damage to
safety system!
MAINTENACE AND CLEANING
In relation with the use of the machine, wash periodically all parts in
contact with the liquid cream. They can be manually taken out from
the machine. The gaskets may be left in position when the parts are
removed.
QUICKLY WASH WITHOUT DISMALTING
Press the ON/OFF switch "5" (Fig. 1) the green led will light, place an
empty receptacle on the plate, detach the tube "24" (Fig. 3), and
press the delivery button "2" (Fig. 1) while pouring a lukewarm
detergent solution into the regulator funnel "1" (Fig.1).
ASSEMBLY, DISMALTING, SPARE PARTS
View figure 3. To dismantle the delivery outlet-pump for cleaning
operation proceed as follows: slide the pin "24", take the tank away,
loosen the knob "4", slide the bracket "16" out and remove the pump
"3". Unscrew the tube "18", the delivery outlet "20" and slide the
connector "14", the spring "19" and the mixer "17". The pump "10"
can be dismantled just disjoining the cover "15", the diaphragm "13",
the parts "11" and "12" and finally the air-cream regulator.
To assemble, follow the same procedure in reverse order carefully
respecting the orientation of the mixer "11" with the spring orientated
to the delivery outlet "20". Pay attention to insert the diaphragm "13"
in the pump.
Turning without the diaphragm, the pump could be seriously
damaged.
Failure to function does not always depend on the quality of components used. These appliances are manufactured using top quality components.
Failure may be caused by voltage surges, or dust and dirt in the operating components. In any situation where improper functioning of the appliance
is suspected, turn it off and disconnect it from the mains. Call the authorized repair service.
The appliance needs no specific maintenance besides normal cleaning; we do however suggest having it checked once a year by the
assistance centre for which, we recommend drawing up a maintenance contract.
Our appliances are studied and optimised, with lab tests, to provide
high performance and yields. However, to keep energy consumption
low, we suggest not using the appliance for any length of time if it is
empty or in conditions that compromise optimum yield.
All packaging materials are environment-friendly. They can be kept
without problem or burnt in a waste incinerator plant. The plastic
components that can be recycled are:
■ Polyethylene: external packaging material and/or pluribol film
■ Polypropylene: straps
■ Polystyrene foam: corner pieces, sheets and protection blocks
CLEANING AND CARE OF THE APPLIANCE
FAILURE TO FUNCTION PROPERLY
MAINTENACE
ECOLOGY AND ENVIRONMENT
After screwing on the tube "18", the connector "14" and the delivery
outlet "20", positioning its outlet down, assemble the pump set,
inserting it in its own seat. In order to engage the pump, let the
engine turn for a little while, pushing the delivery button, "2". Insert
the bracket "16" and slide it in its seat until it stops. Finally tighten the
locking knob "4" manually, without forcing.
14
17
18
19
20
22
21
23
At the end of the appliance's useful life, dispose of it properly.
90% of each appliance is made of metal (stainless steel, iron,
aluminated sheet, etc.) hence it can be recycled by the relative
recycling organisations in compliance with the standards in force in
your country.
In observance of the dismantling regulations completing remove the
power cable.
The Manufacturer declines any responsibility for damage
caused by improper or incorrect installation or maintenance
of the appliance, or failure to observe safety regulations!
10
15 13 12 11
1
16
4
24
Fig.3