Dip Switch Configuration - AERMEC ECA Série Manuel D'installation

GB

DIP SWITCH CONFIGURATION

Turn off the power to the unit.
To be done in the installation phase, only by expert personnel.
By turning on or off Dip-Switches inside the thermostat, we get the following functions:
SW 1
Dip 1 (Default OFF )
Electric heater control:
- integration operation, OFF
- substitution operation, ON
Dip 2 (Default OFF )
Presence of the electric heater:
- absent, OFF,
- present, ON
Dip 3 (Default OFF)
Factory settings.
Dip 4 (Default OFF)
Factory settings.
Dip 5 (Default OFF)
Outdoor unit:
- cooling only, OFF
- heat pump, ON
Dip 6 (Default OFF)
Ventilation control:
- continuous ventilation, OFF
- thermostat ventilation heating mode, ON.
Dip 7 (Default ON)
Factory settings, ON
Dip 8 (Default ON )
Factory settings, ON
22
RXCE electric heater control, substitution function
Presence of the electric heater, RXCE present
ON
1 2 3 4 5
OFF
Presence of the electric heater, RXCE absent
RXC-E Electric heater control, fonctionnement en intégration
ON
5
1 2 3 4
OFF
Heating pump
Ventilation control, thermostat ventilation at hot
Factory settings
Sw1
6 7 8
Continuous ventilation
Cooling only
Factory settings
Factory settings
Sw2
6 7 8
Factory settings
SW 2
Dip 1 (Default OFF )
Factory settings.
Dip 2 (Default OFF )
Factory settings.
Dip 3 (Default OFF)
Factory settings.
Dip 4 (Default OFF)
Factory settings.
Dip 5 (Default OFF)
Factory settings.
Dip 6 (Default ON)
Factory settings.
Dip 7 (Default OFF)
Factory settings.
Dip 8 (Default ON )
Factory settings.
Fig. 2