Dip-Switch Settings - AERMEC GLL10R Série Manuel D'installation

DIP-SWITCH SETTINGS

emove voltage to the unit.
To be carried out in the installation phase by specialised staff.
SW2 contains settings that must not be modified (the default settings are given in the table).
By acting on the Dip-Switches of the SW1 the following functionalities are obtained:
SW 2
Dip 1 (Default OFF)
Factory settings.
Dip 2 (Default OFF)
Factory settings.
Dip 3 (Default OFF)
Factory settings.
Dip 4 (Default OFF)
Factory settings.
Dip 5 (Default OFF)
Factory settings.
Dip 6 (Default OFF)
Factory settings.
Dip 7 (Default OFF)
Factory settings.
Dip 8 (Default ON)
Factory settings.
SOME EXAMPLES:
FCL 2 pipes (default)
1 2 3 4 5 6 7 8
FCL 2 pipes + Resistance (only for models with Module 600)
1 2 3 4 5 6 7 8
FCL 4 pipes
1 2 3 4 5 6 7 8
FCL 4 pipes + Resistance (only for models with Module 600)
1 2 3 4 5 6 7 8
OFF
ON
SW2
OFF
ON
SW2
OFF
ON
SW2
OFF
ON
SW2
SW 1
Dip 1 (Default OFF)
Resistance control:
- functioning in integration mode, OFF
- functioning in replacement mode, ON
Dip 2 (Default OFF)
Presence of the resistance:
- with resistance, OFF
- with resistance, ON
Dip 3 (Default OFF)
Type of plant:
- 2 pipes, OFF
- 4 pipes, ON
Dip 4 (Default OFF)
Factory settings.
Dip 5 (Default OFF)
Factory settings.
Dip 6 (Default OFF)
- continuous ventilation, OFF
- thermostat ventilation heating mode, ON
Dip 7 (Default ON)
Factory settings, ON
Dip 8 (Default ON)
Factory settings, ON
1 2 3 4 5 6 7 8
SW1
1 2 3 4 5 6 7 8
SW1
1 2 3 4 5 6 7 8
SW1
1 2 3 4 5 6 7 8
SW1
AGLLRIJ 0907 - 4528560_03
OFF
ON
OFF
ON
OFF
ON
OFF
ON
23