AERMEC GLL10R Série Manuel D'installation page 17

INSTALLATION
ATTENTION: before carrying out any
intervention, make sure that the elec-
tric power supply has been disconnec-
ted.
CAUTION: before carrying out any
work, wear the appropriate individual
protection devices.
ATTENTION: The appliance must be
installed in compliance with national
regulations on this subject.
ATTENTION: the electric connections,
the installation of the fan coils and
their accessories must only be perfor-
med by subjects with the technical-
professional requisites for enabling
and installation, transformation, exten-
sion and maintenance of the systems
and able to check the same for safety
and functionality purposes (in this
manual they will be indicated by the
generic term "staff with specific tech-
nical skill").
In particular, for the electric connec-
tions, checks relative to the following
are requested:
- Measurement of the electric plant iso-
lation resistance.
- Continuity test of the protection wires.
• INSTALLATION IN PROXIMITY OF A WALL
If installed in proximity of a wall it is possible to
close the corresponding flow inlet using the gasket
supplied.
ATTENTION: Install a device, master
switch or electric plug that allows to
completely interrupt the appliance's
electric power supply.
Here find the essential indications for
correct installation of the appliance.
The completion of all operations, accor-
ding to specific requirements, is left to
the experience of the installer.
Also consult the FCL installation manual
and the user manual supplied with the
grid unit.
Generally the best position of the louve-
red fins is that that allows the launch
of the air adhering to the ceiling for
the coined effect, during cold functio-
ning. The side section of the deflec-
tors (Module 600)shows the opening
positions for proper warm functioning
(opening 20°) and cold functioning
(opening 10°) of the machine.
For the Module 840 units, it is recom-
mended to completely open the deflec-
tor in heating mode. In cooling mode,
rotate the deflector to half way.
Depending on the user's requirements, it
is possible to position the louvered fins
in the intermediate of complete closure
positions. Thanks to the special shapes
of the louvered fins the machine can
also function with the deflectors com-
pletely closed.
Do not install at height of above three
metres.
The FCL unit is set for connection with
fresh air ducts and for the flow of the
treated air in an adjacent room.
AGLLRIJ 0907 - 4528560_03
17