Optional Table Rollers; Maintenance - Robland D-510 Mode D'emploi

Optional table rollers

(Fig.9)
The rollers in the thicknesser table can be raised by simply turning the two serrated
knobs as indicated on the pictogram.
Fig.9

Maintenance

Attention: Always disconnect the machine from its power supply before starting all mainte-
nance works !!
The interior parts of the machine must be cleaned regulary in order to avoid an accumulation of dust
and woodchips.
Any possible deposit of resin on the various parts of the machine must be taken away with a piece of
cloth and a little solvent (petrol, kerosine or other product)
After removing the front and back cover plates, all machine parts which need maintenance are ex-
posed.
The thread bars and posts of the table and the drive chains of both rise and fall of the table and the
feeding mechanism must be cleaned and greased on a monthly base using a thin oil such as WD-40.
The use of a dust extractor system will most certainly extend the life of your machine.
The life of the motors can be extended by blowing out saw dust from the cooling fan and from the mo-
tor body itself.
Never smoke or have any naked flame near the machine when using inflammable products, this
to prevent risk of fire and serious burns for the operator !!
50
V0214 D 510
Nederlands Français English Deutsch