Thicknesser Feed - Robland D-510 Mode D'emploi

Thicknesser feed

Important:
Before starting to work on the thicknesser always ensure that the anti-kickbackprotection fingers are
clean and hang down freely in position under their own weight.
These anti-kickback fingers should be inspected on a regular base, and kept clean and free of any
resin deposits whatsoever.
Ensure the correct position and locking of the dust chute.
Roller supports should be used when long workpieces are machined.
Ensure the ticknesser table is well cleaned, since a smooth table surface is essential for good opera-
tion of the thicknesser.
The machine is equipped with a 4-speed selector switch, for feeding speeds from 5/8/10 and 16 m/min.
The feeding motor is started-up by pushing the start button, and by turning the selector switch a feed-
ing speed can be selected.
Changing over from one speed to an other can be done without having to stop the feeding motor.
In case of overload of the feeding mechanism the feeding motor must be disengaged immediately by
pushing the stop button or the emergency stop button on the switch panel.
After reducing the depth of cut on the thicknesser, the motor can be started-up again.
Fig.8
V0214 D 510
(Fig.8)
4-speed selector
switch for feed
speed
Deutsch
START motor
feeding of the wood
English Français
49
Nederlands