Sonnenkonig CAVA 142 Notice D'utilisation page 96

11. Operating your wine cooler
If the ambient temperature is above or below the recommended ambient temperature range,
the performance of the appliance may be affected. Positioning the appliance where conditions
GB
are too cold or too hot may cause interior temperatures to fluctuate.
Note: When you use the wine cooler for the first time or restart the wine cooler after it has
been switched off for a long time, there could be a few degrees variation between the tempera-
ture you select and the temperature indicated on the LED display. This is normal and due to the
length of the activation time. Once the wine cooler has been running for a few hours, everything
will return to normal. If the unit is unplugged or switched off due to a power outage, you must
wait 3 to 5 minutes before restarting the appliance. If you attempt to restart it before this time,
the wine cooler will not start.
1. Main functions
Displays temperature and humidity; Controls temperature automatically; Controls lighting;
Alarm if temperature exceeds the temperature limit; Switches between Fahrenheit and Celsius.
2. Technical information:
Temperature range: -45°C – +99°C (-45 F – 210 F)
Resolution: 0.1 C°
Relative humidity: 0 – 99 % RH
Temperature accuracy: ± 1°C (-40°C – 50°C), ± 2 °C (50°C – 70°C)
Temperature control range: : 5°C – 20°C
Power supply: 220 – 240 V, 50 / 60 Hz
Relay contact capacity: cooling 10 A / 240 V; heating 5 A / 240 V
Fan: 12 V / 120 mA
Lighting: 12 V / 120 mA
3. Operation and panel diagram
3.1 On / Off: Press and hold the on/off button for 5 seconds to switch off the system. Press the
on/off button again to display the set temperature value. After a delay, the cooling system
starts to work.
3.2 Lighting: Permanent light: Press the lighting button to turn on the light. The icon appears
on the display. When the light is on, press the lighting button again, and the light-off icon
will disappear from the display.
3.3 Adjusting the temperature: Press the SET button to adjust the room temperature. Press
the upward button or downward button to change the temperature (the default setting is
96