LG LP6000ER Manuel D'utilisation page 15

(a) When window frame is located on inner sill.
• Install a wood strip (window width long and
window frame height high) on the inner sill.
SASH WINDOW
WINDOW FRAME
WOOD STRIP
INNER
SILL
(b) When the window frame is higher than
19/32"(15mm)
• Install a wood strip (about 4"(102mm) long) on
the outdoor sill to raise support bracket.
WINDOW FRAME
19/32"(15mm)
INNER
SILL
Electrical Safety
Line Cord Plug
Do not under any
circumstances cut
or remove the
grounding prong
from the plug.
Power supply cord with
3-prong grounding plug
Use of extension cords
• Because of potential safety hazards, we strongly discourage the use of an extension cord. However, if you wish
to use an extension cord, use a CSA certified/UL-listed 3-wire (grounding) extension cord, rated at 15A, 125V.
REMOVAL FROM WINDOW
• Turn off and unplug the air conditioner.
• Unscrew the side screws that you installed in Step 5.
• Close the curtain frame and remove foam seal and L
• Keep a firm grip on the air conditioner raise the
• Lift the air conditioner from the window and remove
• Remove the support bracket from window frame.
NOTE: When cooling season is over, unit is removed
from window for cleaning and storage. There may still
be some condensation water in the basepan. Remove
the unit carefully to avoid water being spilled out on
OUTER
SILL
floor, always store unit flat on its base. Do not stand
on end. Be sure to remove support bracket, L bracket,
and foam seal from window and save. Window will not
close if support bracket remains installed.
WOOD STRIP
OUTER
SILL
FIG. 9
Use Wall Receptacle
Standard 125V, 3-wire grounding
receptacle rated 15A, 125V AC
15
6.
bracket from the windows.
sash.
the foam strip from between the windows.
CAUTION
• Air conditioners covered in this manual pose an
excessive weight hazard. Two or more people are
needed to move and install the unit.
To prevent injury or strain, use proper lifting and
carrying techniques when moving unit.
• When handling the air conditioner, be careful to
avoid cuts from sharp metal fins on front and rear
coils.
• Make sure air conditioner does not fall during
removal.
Power Supply
Use 15 AMP, time
delay fuse or circuit
breaker.