Cebora SYNSTAR TWIN 270 T Manuel D'instructions page 26

5 CONTROLS LOCATED ON REAR PANEL
H
6 DESCRIPTION OF FUNCTIONS SHOWN ON THE DISPLAY SCREEN A
Machine
Version
Build Feb 8 2019
Table
letters PP if a push-pull welding torch is used, the welding process "SHORT or PULSED"(optional), the welding cur-
rent, the speed of the welding wire in metres/min, the welding voltage and the recommended thickness. To increase or
decrease the welding parameters, simply adjust by means of knob B. The values all change together in a synergic way.
To change the welding voltage V, simply press the knob B for less than 2 seconds. The display screen will show (Arc
Length) an adjustment bar with central 0. The value can be changed by means of the knob B from -9.9 to 9.9. To exit
from the function, briefly press the knob B.
By changing the value, once having exited the sub-menu, alongside the voltage V, an arrow will appear turned upwards
to indicate a higher adjustment of the set value, while the arrow turned downwards will indicate a lower adjustment.
26/33
When the machine is switched on, for a few moments the display screen A displays: the article
number of the machine, the version and development date of the software, and the release
number of the synergic curves (this information is also given in Section 7.1 SERVICE FUNC-
344
TIONS).
001
Immediately after switch-on, the display screen A shows:
001
The synergic curve used, the welding mode 2T, 4T or 3L, SPOT function, if active, the
G – MAIN CABLE
F– SWITCH�
F
Starts and stops the machine
G H – GAS PIPE CONNECTIONS�
H
3301051/B