Cebora SYNSTAR TWIN 270 T Manuel D'instructions page 24

3�5 Lifting and transport
For lifting and transport methods, refer to Warnings Manual 3301151�
3�6 Installation and start up
The machine must be installed by professional personnel. All connections must be carried out according to current
regulations, and in full observance of safety laws (CEI 26-36 and IEC/EN 60974-9).
Make sure that the mains voltage matches the voltage indicated on the specifications plate of the power
source�
Connect a plug of adequate capacity for the current consumption I1 indicated on the data plate.
Make sure that the yellow/green conductor of the power cable is connected to the plug's earth contact.
The capacity of the overload cut-out switch or fuses, positioned between the power supply network and the power
source, must be adequate for current I1 consumed by the power source.
The power source is turned on and off using switch F.
If accessories are present in the welding system, they must be connected to the power source before powering
up. Connecting/disconnecting accessories while the power source is switched on leads to system malfunctions
and under extreme circumstances could compromise the integrity of the welding system. CEBORA SpA does not
provide warranty coverage for inappropriate use of the welding system.
The use of non-original accessories may compromise the correct operation of the power source and even the
integrity of the system, rendering any warranty and liability cover that CEBORA S.p.A. may provide for the welding
power source null and void.
Position the welding machine so as to allow the free circulation of air inside and, as much as possible, prevent metal
or other dusts from penetrating. Position the welding machine in an area that ensures good stability.The weight of the
welding machine is approximately 68 Kg. Only skilled personnel should install the machine.All connections must be
carried out in compliance with current standards (IEC/CEI EN 60974-9) and in full observance of current safety laws.
Make sure that the supply voltage corresponds to the rated voltage of the welding machine.Size the protective fuses
based on the data listed on the technical specifications plate. Mount the plug on the power cord, being especially
carefully to connect the yellow/green conductor to the earth pole. This welding machine has been designed to con-
temporarily mount 2 welding torches and 2 coils of wire having one a diameter of MAX 300 mm and the other one of
MAX 200 mm .
This power source cannot weld with the 2 torches at the same time, the choice of wich torch and type of
metal to weld is made simply by pressing and releasing for a few moments the start button of any of the two
torches�
The rear shelf can hold 2 cylinders having diameter MAX (180mm - 7.1in) and height MAX (1000mm - 39.4in) or only
1 cylinder having diameter MAX (220mm – 8.7in) and height MAX (1600mm – 63in). The cylinders must be firmly fixed
to the cylinder shelf by means of the belts provided.
The gas cylinder must be equipped with a pressure regulator and a gauge.
Only after positioning the cylinder, connect the outgoing gas hose from the rear panel of the machine to the pressure
regulator.
24/24
DANGER
WARNING
NOTICE
NOTICE
3301051/B