Publicité
Les langues disponibles
Les langues disponibles
GB
1.6
Starting procedure
Caution:
Fully charge the battery before using for the first time!
•
Insert fully charged battery in correct position into housing.
•
Select correct nosepiece (A) according to table 1.4.
•
To screw in the nosepiece (A), activate the trigger (H) and proceed until the stop position
has been reached at the back.
•
Then remove the battery. Screw in the nosepiece (A) and tighten it using the wrench
provided. Put the battery back in and activate the trigger (H).
Details for use of the iBird® Pro can be found in the iBird
the "Operation & maintenance" section.
1.6.1 To attach spent mandrel container
•
Fully screw on spent mandrel container (H) by turning clockwise.
1.7
Mode of operation
The blind riveting tool features optimised operating speed. After inserting the blind rivet, the
blind riveting tool can be operated in two different modes:
a. Pressing and holding the trigger (H):
Pressing and holding the trigger (H) starts the riveting process. The riveting process stops
automatically when the rear end position is reached. The blind rivet extractor returns automat-
ically to the front starting position only when the trigger (H) is released.
b. Tapping the switch:
Briefly tapping and immediately releasing the trigger (H) does not start the riveting process.
As soon as the mandrel breaks off, the blind riveting tool stops and automatically re-assumes
the front starting position.
•
Eject the spent mandrel by tilting to the rear into the spent mandrel container or to the
front through the nosepiece.
•
The blind riveting tool is equipped with overload protection. In the event of overloading
the blind riveting tool, e.g. by setting rivets that are outside the working range, riveting
stops, indicated by the 3 LEDs flashing slowly (1 Hz). Press the switch to make the blind
riveting tool go back to the start position and it is then ready for operation.
•
The control detects a blockage on return (e.g. dirt, foreign object, etc. in the steel head
sleeve). The tool stops the return procedure and immediately assumes the rear end posi-
tion automatically. The fault is indicated by the LEDs flashing rapidly (2 Hz). The battery
pack must be removed and the fault eliminated. Then reinsert the battery and briefly
press the switch. The tool assumes the front end position and is again ready for use.
20
Pro App under
®
Publicité
