Assembly - JVC SX-XD33 Manuel D'instructions

Assembly

Assembling the satellite speakers
Each speaker (except the center speaker) has been divided into
three parts for shipment. Before using this speaker system,
assemble it first by following the procedure below.
Speaker
section
• Prepare a Phillips screw driver.
Before assembling—
• Take care not to drop the stand while assembling;
otherwise, it may cause damage to the floor or injury.
• Ensure enough space for assembly and installation.
• Place a large, thick cloth on the floor where you
assemble the speaker, so you can protect the floor and
the speaker itself.
• Use the speaker only after assembly is fully and correctly
done.
Attaching the leg and the stand
1
Remove the terminal cover from the leg.
First remove the screw on the terminal cover, then detach
the cover by pulling it upward.
• You will need to use the removed screw in step 5 on page
5.
Screw
Leg
Leg Stand
Terminal
cover
claws
grooves
2
Join the leg to the stand.
• Rotate either the leg or stand so that the
leg and the mark on the stand are facing the same
direction.
• Make sure to match the screw holes on the leg with those
on the stand so that they are aligned correctly.
mark
3
Fix the leg to the stand with three of the
supplied screws (long: M4 x 25 mm).
• Do not tighten each screw completely as you put them in
place.
First put all screws in, then tighten them evenly and firmly.
It is recommended to place a cushion under the leg.
• You can tighten the screws easily by placing the leg
horizontally.
– 4 –
mark on the
Leg
Stand
mark
Leg
Stand
Screw
Cushion