Installation - IKEA SMAKLIG Mode D'emploi

ENGLISH
Problem
symbol plus a number
appears on the heat setting
display.
lights up on the heat
setting display.
If there is a fault, first try to find a solution to
the problem yourself. If you cannot find a
solution to the problem yourself, contact
your dealer or an After Sales Service.

Installation

General information
Manufacturer is not responsible for any
injury to persons and pets or damage to
property caused by failure to comply
following requirements.
Caution! To proceed with the
installation refer to the assembly
instructions.
Possible cause
Electronics fault.
Overheating protection for
the cooking zone operates.
Remedy
Disconnect the appliance
from the electrical supply for
a few minutes. Take the fuse
out of the house's electric
system. If after switching on
again, is displayed
again, call an After Sales
Service.
Switch off the appliance. Re-
move the hot cookware. Af-
ter approximately 30 sec-
onds switch on the cooking
zone again.
appear, residual heat indi-
cator can stay. Cool down
the cookware and check it
with the section "Cookware
for the induction cooking
zones".
If you operated the appliance
wrongly, or the installation was
not carried out by a registered
engineer, the visit from the After
Sales Service technician or
dealer may not take place free
of charge, even during the
warranty period.
Warning! Installation process
must follow the laws, ordinances,
directives and standards
(electrical safety rules and
regulations, proper recycling in
accordance with the regulations,
etc.) in force in the country of use!
15
should dis-