Publicité
Les langues disponibles
Les langues disponibles
V4.2
8.
Connect the gas hose from the gas cylinder regulator to the gas inlet on
the rear of the welding machine. Open the valve on the gas cylinder and set
the flow between 21 to 30 CFH. Check for gas leaks.
9.
Proceed to the welding task.
SET-UP FOR ARC (STICK) WELDING
The electrode may require either a positive or a negative charge for optimum results.
Consult the electrode manufacturer's information for the correct polarity set-up. The
default configuration for ARC is with the ground lead connected to the negative power
socket and the electrode holder connected to the positive power socket.
1.
Plug the electrode holder cable into the power socket appropriate to the
electrode type. Plug the ground cable into the other power socket and
clamp onto the workpiece.
2.
Turn the power source on and push the welding selection key (N) under
welding mode (M) to select welding mode DC Stick.
3.
Press the parameter selection key (Q) to choose current.
4.
Turn the adjustment knob (O) to increase or decrease the amperage on the digital
display. Press the knob to set the amount of current supplied to the electrode.
a.
When using a foot pedal with the welding unit, the number in the
digital display is the maximum amperage supplied to the electrode.
5.
Hold the electrode holder away from the workpiece and insert the electrode.
6.
Proceed to the welding task.
CARE & MAINTENANCE
1.
Maintain the tool with care. A tool in good condition is efficient, easier to
control and will have fewer problems.
2.
Inspect the tool components periodically. Repair or replace damaged or
worn components. Only use identical replacement parts when servicing.
3.
Follow instructions for lubricating and changing accessories.
4.
Only use accessories intended for use with this tool.
5.
Maintain the tool's labels and name plates. These carry important information.
If unreadable or missing, contact Princess Auto Ltd. for replacements.
WARNING! Only qualified service personnel should repair the tool. An
improperly repaired tool may present a hazard to the user and/or others.
Visit www.princessauto.com for more information
200A AC/DC Dial Control TIG Welder 202KE
8785081
23
Publicité
