Dimplex DF1135M Manuel Du Propriétaire page 14

Operation
battery cover (Figure 10).
Remote Control Initialization/
Reprogramming
If the remote control or remote
control receiver has been
replaced, follow these steps to
initialize the remote control and
receiver:
1. Ensure that power is supplied
through the main service
panel.
2. Turn On/Off Switch to " I "
(Figure 9A).
3. Move the 3-Position Switch
to the " REMOTE " position
(Figure 9B).
4. Press and hold the Manual
Control Button marked " I " for
five (5) seconds (Figure 9C).
After five (5) seconds, there is
a 10 second window to press
any button on the remote
control.
5. Press any button on the
remote control within that 10
seconds.
This will synchronize the remote
control and receiver.
!
NOTE: You will have only 10
seconds to perform this last step.
Failure to do so will result in these
steps needing to be followed
14
again.
Battery Replacement
To replace the battery:
1. Slide battery cover open on
the remote control (Figure
10).
2. Install one (1) 12-Volt (A23)
battery in the battery holder.
3. Close the battery cover.
Battery must be recycled
or disposed of properly.
Check with your Local
Authority or Retailer for recycling
advice in your area.
www .dimplex.com