Dimplex DF1135M Manuel Du Propriétaire page 13

Operation
C. Manual Control Buttons
The Manual Control Buttons
operate the fireplace levels
sequentially (from off): flames
only; to flames and low heat; to
flames and high heat.
The level is increased every time
the "I" button is pressed, and the
fireplace can be turned off at any
point by pressing the "O" button.
Resetting The
Temperature Cutoff
Switch
Should the heater overheat, an
automatic switch will turn the
heater off and it will not come
back on without being reset.
The temperature cutoff switch
can be reset by unplugging the
unit, waiting five (5) minutes and
plugging the unit back in.
CAUTION: If you need to
continuously reset the heater,
unplug the unit and call
Dimplex customer service at
1-888-DIMPLEX
(1-888-346-7539).
Remote Control
The fireplace is supplied with a
radio frequency remote control.
This remote control has a range
of approximately 50 feet (15.25
Figure 10
On
Button
Off Button
Plastic
Strip
Battery
Cover
m), it does not have to be pointed
at the fireplace and can pass
through most obstacles (including
walls). It is supplied with one
of hundreds of independent
frequencies to prevent
interference with other units.
Remote Control Usage
The remote control operates the
fireplace levels sequentially (from
off): flames only; to flames and
low heat; to flames and high heat.
The level is increased every time
the ON button is pressed on the
remote control and the fireplace
can be turned off at any point by
pressing the OFF button.
!
NOTE: Before attempting any
operation with the remote, pull
the plastic insulator strip out from
between the remote casing and
13