Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
6 | English
If the plug is not suitable for your socket outlets, it should be
cut off and an appropriate plug fitted in its place by an au-
thorised customer service agent. The replacement plug
should have the same fuse rating as the original plug.
The severed plug must be disposed of to avoid a possible
shock hazard and should never be inserted into a mains
socket elsewhere.
Product Description and
Specifications
Please observe the illustrations at the beginning of this oper-
ating manual.
Intended Use
The power tool is intended for bending and welding plastic,
stripping coats of paint and heating shrink tubing. It is also
Technical Data
Heat gun
Article number
Voltage
Rated power input
Airflow
Temperature at the nozzle outlet
Temperature measurement accuracy
Weight according to EPTA-Procedure 01:2014
Protection class
A) At an ambient temperature of approx. 20 °C
The specifications apply to a rated voltage [U] of 230 V. These specifications may vary at different voltages and in country-specific models.
Noise/vibration information
Typically, the A-weighted sound pressure level of the power
tool is less than 70 dB(A).
Total vibration values a
(triax vector sum) and uncertainty
h
2
2
K: a
<2.5 m/s
, K=1.5 m/s
.
h
Operation
Starting operation
Pay attention to the mains voltage. The voltage of the
u
power source must match the voltage specified on the
rating plate of the power tool.
Creation of Smoke During Initial Use
A coating protects the metal surfaces from corrosion ex-
works. This protective layer evaporates during initial use.
Switching On
Slide the on/off switch (2) upwards.
Thermal protection shutdown: If the power tool overheats
(e.g. due to a build-up of air), the heating system will auto-
matically switch off, though the blower will continue to run.
Once the power tool has cooled back down to its operating
1 609 92A 4FD | (04.10.2018)
suitable for soldering and tinning, melting adhesive bonding
and thawing water pipes.
Product Features
The numbering of the product features refers to the diagram
of the power tool on the graphics page.
V
W
l/min
A)
°C
kg
temperature, the heating system will automatically switch on
again.
Switching Off
Slide the on/off switch (2) downwards into the 0 position.
u
Selecting a Power Setting
You can choose between different power settings using the
on/off switch (2):
The I power setting is suitable for cooling down a heated
workpiece or for drying paint. It is also suitable for cooling
down the power tool before putting it down or changing the
attachment nozzles.
(1) Storage surface
(2) On/off switch and power settings
(3) Nozzle
(4) Heat shield
A)
(5) Glass protection nozzle
A)
(6) Reducing nozzle
A) Accessories shown or described are not included with the
product as standard. You can find the complete selection of
accessories in our accessories range.
GHG 180
3 601 J4D 0..
127
1500
350/350/550
50/350/525
±15 %
0.65
/Ⅱ
After working at high temperatures for a prolonged
period, let the power tool cool down before switching
it off. To do this, allow it to run on the lowest temper-
ature setting for a short while.
Power setting
I
II
III
GHG 180
3 601 J4D 0..
230
1800
350/350/550
60/350/550
±15 %
0.65
/Ⅱ
°C
l/min
60
350
350
350
550
550
Bosch Power Tools
Publicité
Table des Matières
