Initial Use; Use; Cleaning And Maintenance; Technical Specifications - Sanitas SFB 07 Mode D'emploi

7. Initial use

• Remove the packaging
• Check the device, power supply and cables for damage.
• Before you plug in the foot bath, fill it up to the fill-level mark (approx 4 cm full) with either warm or
cold water. The foot rest should, however, be completely covered with water.
• Route the cable safely so that there is no risk of anyone tripping over it.
• Place the foot bath on a firm and level surface.

8. Use

Make yourself comfortable in a chair and place your feet on the foot rest and apply slight pressure.
Never stand up in the foot bath. The rubber feet on the base of the unit prevent it from sliding.
Switch on the device. To do this, press the function button [2].
The vibration massage, bubble massage and maintains water temperature control are started simul-
taneously.
Massage attachment
The massage attachment in the middle provides a comfortable massage for your feet and stimulates
the circulation. This can be removed for cleaning purposes.
Note
• Massage of a specific point on the sole of the foot may influence the corresponding organ of
the body. However, we recommend studying relevant literature and asking your doctor before
using point reflex zone massage to achieve the desired effect.
• A heater is fitted underneath the feet support. Warm water can be kept warm for a longer
length of time by switching on the heater. The heater is not suitable for heating cold water. To
achieve optimum results, it is recommended that the massage lasts no longer than 40 minutes.
After use, empty the water using the foot bath's narrow draining outlet [8].

9. Cleaning and maintenance

After use rinse the unit with tap water. The foot bath can be cleaned with a mild, non-foaming house-
hold cleaner, e.g. neutral vinegar.
To dry out the air line after cleaning, switch on the bubble setting for approximately 10 seconds.
Drops of water emerging from the bubble bar can be wiped away with a cloth.
Note
• Do not allow water to penetrate the interior of the footbath.
• Store the footbath in its original packaging in a dry area.
• Do not leave it open for an extended period.

10. Technical specifications

Supply:
Dimensions:
Weight:

11. Disposal

For environmental reasons, do not dispose of the device in the household waste at the end
of its useful life. Dispose of the unit at a suitable local collection or recycling point. Dispose
of the device in accordance with EC Directive – WEEE (Waste Electrical and Electronic
Equipment). If you have any questions, please contact the local authorities responsible for
waste disposal.
220-240 V~, 50/60 Hz, 60 W
34.5 x 38.0 x 13.0 cm
approx. 1.3 kg
13