Troubleshooting - LawnMaster MEB1016M Guide D'utilisation

TROUBLESHOOTING

Problem
Handle not in position.
0RZHU FXWWLQJ JUDVV
unevenly.
0RZHU QRW PXOFKLQJ
properly.
0RZHU KDUG WR SXVK
0RZHU YLEUDWLQJ DW
higher speed
Possible Cause
Carriage bolts not seated properly.
Cam locks not tightened.
([WHQVLRQ FRUG QRW FRQQHFWHG WR
WKH PRZHU SOXJ
([WHQVLRQ FRUG QRW FRQQHFWHG WR
SRZHU VRXUFH
Tripped circuit breaker in the house.
0RWRU FRQWURO VZLWFK GHIHFWLYH
/DZQ LV URXJK RU XQHYHQ RU FXWWLQJ
height not set properly.
Wet grass clippings sticking to the
underside of the deck.
+LJK JUDVV UHDU RI PRZHU KRXVLQJ
and blade dragging in heavy grass,
RU FXWWLQJ KHLJKW WRR ORZ
Blade is unbalanced.
Bent motor shaft.
22
Solution
Adjust the height of the handle
and make sure the carriage bolts
are seated properly.
Tighten cam locks.
Reconnect the cord and use the
cord retainer to keep the cord
close to the motor/blade control.
&RQQHFW WKH H[WHQVLRQ FRUG WR D
OLYH 9 $&  += $&
receptacle.
Reset house circuit breaker.
,I LW WULSV DJDLQ FDOO D TXDOLILHG
electrician.
+DYH PRWRU FRQWURO VZLWFK
replaced by an authorized
service center.
0RYH WKH ZKHHOV WR D KLJKHU SRVL
WLRQ $OO ZKHHOV PXVW EH SODFHG LQ
the same cutting height for the
PRZHU WR FXW HYHQO\
Wait until the grass dries before
PRZLQJ
Raise cutting height.
Balance the blade by grinding
HDFK FXWWLQJ HGJH HTXDOO\
Stop the motor, disconnect the
SRZHU VRXUFH DQG LQVSHFW IRU
damage. Have repaired made by
an authorized service center
before restarting.