Publicité
Les langues disponibles
Les langues disponibles
H
• Remove the burner cover and secure the two hoses to the fittings
of the fuel pump already in place;
Warning
The diesel burner is factory-set according to the
parameters shown on the "TECHNICAL SPECIFICATIONS
TABLE" for 50Hz models.
For 60Hz models, you have to change the combustion air
setting as shown on the Table.
4.4.2. ECOFLAM BURNER
• Open the box containing the diesel burner, remove it and keep the
two stickers with lot number for later use;
• Secure the burner plate to the machine by using the 4xM8 screws;
• Insert the burner and fix it to the plate by tightening the nut
supplied onto the central screw;
• Locate the black cable with 7-pin Wieland plug running out of the
electrical panel and insert the plug into the socket H on the
burner;
• The ECOFLAM burner is factory-set according to the data shown
on the Technical Specifications Table in the User Manual.
Warning
The diesel burner is factory-set according to the
parameters shown on the "TECHNICAL SPECIFICATIONS
TABLE" for 50Hz models.
For 60Hz models, you have to change the combustion air
setting as shown on the Table.
4.4.3. DIESEL FILTER
• Mod. 145 kW - 185 kW - 235 kW. Take the diesel filter and nipple
L. Place aluminium washer N between the connection and nipple L
and screw the nipple fully down.
N
Warning
The threaded portion with internal conical chamfer M
must protrude in order to allow seal tightening with the
hose.
• Remove the through nipple and secure it to the diesel filter by
inserting the shorter threaded part into the filter, taking care to
place aluminum seal N between them.
P
N
• On the top left side of the burner box, secure the diesel filter unit
and secure it to the metal panel by tightening with the ¼" nut.
• On the bottom left side of the burner box, secure second through
nipple and secure it to the metal panel by tightening with the ¼"
L-L 249.00-SO
M
L
EN
nut.
Warning
The threaded portion with internal conical chamfer M
must protrude in order to allow seal tightening with the
hose.
• Screw the flexible suction hose of the pump onto fitting M on the
diesel filter unit.
• Screw the flexible supply pipe of the pump onto the second
through nipple.
• Close the burner cover;
• Apply one of the two stickers with the serial number on the
nameplate of the machine characteristic data:
• Apply the second sticker with the serial number on the Assembly
and Installation Declaration contained in the user manual:
4.5. CONNECTION TO FUEL SUPPLY
Warning
The heater must be installed, set up, and used in
compliance with all applicable regulations.
Connection to the diesel supply pipe can be made by connecting the
fuel tank to the burner pump:
• directly, i.e., by using the burner's diesel pump, in conformity to
the dimensions and lengths specified in the burner instruction
39 / 84
Publicité
