brondell SE600 Mode D'emploi page 15

PRODUCT INSTALLATION
Swash Installation
11. Plug the Power Cord into an Electrical Outlet
a. If the Power Indicator is not illuminated press any button on
the control panel.
NOTE: Make sure to only use a grounded GFCI (ground fault circuit
interrupter) electrical outlet. In the case of a short circuit, a grounded
GFCI outlet may help prevent electric shock or injury.
12. Fill the Water Reservoir Tank
a. Press either the "Rear" or "Front" button on the remote
control to fill the Water Reservoir Tank with water.
b. The Swash will beep continuously while the tank is filling and
will emit one long beep to indicate when the tank is full.
c. Wait 3-5 minutes for the water to heat up, and the Swash will
be ready for use.
13. Follow instructions on page 19 for using the Swash.
13