Carrier KJR-120X Manuel Du Propriétaire page 10

3. Installation method
5. Wire with the indoor unit
A
1
HA HB
1. indoor unit
2. notch the part for the wiring to pass through with nippers, etc.
Connect the terminals on the remote controller (HA ,HB), and the
terminals of the indoor unit (HA ,HB). (HA and HB do not have
polarity.)
NOTE:
• DO NOT allow water to enter the remote control.
Use the trap and putty to seal the wires.
• Connecting wires must be fixed reliably and cannot be
pulled.
7-GB
B
Fig 3-6
Fig 3-6
60mm
Wiring hole Wiring hole