Creating An All-Purpose Program; Manual Mode - CAME TS07 Manuel Utilisateur

Thermal zones
Bedrooms
Mon Tues Wed Thurs
Copy
Thermo mode:
automatic
06:13
Wednesday 01 March 2017
5
Thermal zones
Heating
Bedrooms
I
Humidity Temperature
06:13
Wednesday 01 March 2017
6
Fri Sat Sun All-purpose
Paste
Internal temperature:
28.2°C
Winter
Home Back
Home Back

Creating an all-purpose program

The all-purpose program can be activated when a variant to the usual
programming is required and it remains active until midnight of the current day .
Once this time has elapsed, the Thermal Zone reverts back to the mode it was in
prior to the [All-purpose] program (manual or automatic) being activated .
Save
On the top bar select the day called [All-purpose], mark the temperature/time
trend you want on the diagram and tap [Save] .
The saved programming can be called up again by moving selector switch 6 I
to [All-purpose] .
Settings

Manual mode

Move selector switch 6 I to [MAN] .
The controller on the right-hand side of the screen can then be used and shows
the current set-point for the Thermal Zone .
The cursor lets you set the temperature you want and the – and + buttons let you
fine-tune the data to tenths of a degree .
The temperature set remains the objective to be reached until it is reprogrammed
or the mode is changed .
Settings
Contents