TFA 98.1030 Mode D'emploi page 8

TFA_No. 98.1030_Anleit_09_21
Radio-controlled alarm clock
with thermometer
Caution!
Risk of injury!
• Keep this device and the batteries out of reach of
children.
• Small parts can be swallowed by children (under
three years old).
• Batteries contain harmful acids and may be haz-
ardous if swallowed. If a battery is swallowed, this
can lead to serious internal burns and death within
two hours. If you suspect a battery could have been
swallowed or otherwise caught in the body, seek
medical help immediately.
• Batteries must not be thrown into a fire, short-cir-
cuited, taken apart or recharged. Risk of explosion!
• Low batteries should be changed as soon as possi-
ble to prevent damage caused by leaking.
• Never use a combination of old and new batteries
together, nor batteries of different types.
• Avoid contact with skin, eyes and mucosa when
handling leaking batteries. In case of contact,
immediately rinse the affected areas with water and
consult a doctor.
Important information
on product safety!
• Do not expose the device to extreme temperatures,
vibrations or shocks.
• Protect it from moisture.
5. Elements Fig. 1
Part A- LCD
A1: RC reception icon
A2: Radio controlled time
A3: Alarm icon
A4: Month and day display
A5: Temperature display
14
17.09.2021 10:22 Uhr
Radio-controlled alarm clock
with thermometer
Part B- Buttons
B1: "SNOOZE/LIGHT" button
B2: "MODE/SET" button
B3: "+(12/24)" button
B4: "-(C/F)" button
B5: "AL ON/OFF" button
Elements Fig. 2
Part C- Structure
C1: Battery compartment
6. Getting started
• Open the battery compartment and remove the
insulation strip. Close the battery compartment
again. The unit is now ready to use.
Radio-controlled time reception:
• After start-up the clock will scan the DCF time sig-
nal ("
permanently when it is received successfully.
Important: Buttons will not function while scanning
for DCF unless they are well received or stopped
manually.
• The clock automatically scans the time signal at
3.00 a.m. everyday to maintain accurate timing. For
failed reception, scanning stops and repeats again
at 4.00 a.m. 5.00 a.m. and 6.00 a.m.
• The clock manually scans the DCF time signal by
holding the"+(12/24)"- button and the"-(C/F)"- but-
ton for 3 seconds. For failed reception, scanning
stops and repeats again the next 4 clock hours.
• Press the "+(12/24)"- button and the "-(C/F)"- but-
ton" again to stop scanning.
• In case the clock cannot detect the DCF-signal (for
example due to disturbances, transmitting distance,
etc.), the time can be set manually. The clock will
then work as a normal quartz clock. (see "Manual
setting of clock and calendar").
Seite 8
" flashes on the LCD). The signal appears
15