Lcd Display; Keypad; Function Description; General Functions - Bahco BDACM1000 Mode D'emploi

BDACM1000

2.2 LCD Display

The LCD screen is shown in Figure
2-2 and the meaning of each symbol
is described in Table 1:
No. Symbol
1
Indicates negative readings.
The device is in autorange mode, in which the device automatically
2 AUTO
selects the range with the best resolution.
AC
3 Indicates AC voltage or current.
DC
4
Indicates DC voltage or current.
5 Low battery indication.
6 H The device is in Data Hold mode.
7 REL The device is in Relative Measurement mode.
8 MAX Display maximum data.
9 MIN
Display minimum data.
10 The device is in Continuity Check mode.
11
The device is in Diode Test mode.
%ºCºF KMΩHz
12
Measurement units.
nμmFAV
13 This symbol means that the input is too high for the selected range.
Auto power off function indication.
Figure 2-2
Meaning

2.3 Keypad

2.3.1 FUNC.
Press to select the second function in the same rotary switch position.
2.3.2 RANGE
On V~, V , , A, mA and μA.
Ω
1. Press RANGE to enter manual range mode.
2. Press RANGE to step through the ranges available for the selected
function.
3. Press and hold RANGE for 2 seconds to return to autorange mode.
2.3.3 MAX/MIN
This key is for measuring maximum and minimum values.
1. Press to enter Max/Min mode.
2. Press again; the LCD displays the maximum value.
3. Press again; the LCD displays the minimum value.
4. Press and hold for 2 seconds to return to normal measurement mode.
(Except Hz/Duty and capacitance)
2.3.4
Press to enter or exit Data Hold mode. Press and hold 2 seconds to switch
on the backlight, or press and hold for 2 seconds to switch off the backlight.

3. FUNCTION DESCRIPTION

3.1 General Functions

3.1.1 DATA HOLD mode

Data Hold mode makes the meter stop updating the display. Enabling Data
Hold function in autorange mode makes the meter switch to Manual ranging
mode, but the full-scale range remains the same. Data Hold function can be
cancelled by changing the measurement mode, pressing RANGE key, or push
key again.
6