Pari VELOX Notice D'utilisation page 53

• Release the tab on the underside of the
device.
• Disconnect the VELOXcare from the
controller.
• Release the tabs on the VELOXcare and open it.
• Take the medication reservoir out.
• Rinse the VELOXcare and the medication reservoir thoroughly with tap water.
The medication reservoir must always be disinfected immediately after rinsing in
the VELOXcare.
If necessary, the VELOXcare can be cleaned and disinfected together with the
nebuliser parts.
Disinfection
The nebuliser, the mouthpiece and the mask must be disinfected once a week
immediately after cleaning. Only parts that have been cleaned can be disinfected
effectively.
CAUTION
A damp environment may encourage the growth of bacteria. Therefore, remove all
parts from the pot or disinfector as soon as disinfection has finished. Dry the parts.
The risk of infection is reduced when the parts are dried completely.
In boiling water
• Place all the individual parts in boiling water for at least 5 minutes.
Use a clean pot and distilled water.
Plastic will melt if it comes into contact with the hot base of the pot. Therefore,
make sure there is plenty of water in the pot. This way you will avoid damaging
the components.
• You can remove excess water more quickly by shaking all parts.
– 53 –
en