Preparation; Installing The Plasma Display; Installing The Media Receiver - Pioneer PureVision PDP-506XDE Mode D'emploi

Preparation

05
Preparation

Installing the Plasma Display

Over 50 cm
Over
10 cm
Location
• Avoid direct sunlight. Maintain adequate ventilation.
• The length of the system cable used to connect the Plasma
Display and the Media Receiver is about 3 m.
• Because the Plasma Display is heavy, be sure to have
someone help you when moving it.
CAUTION
• If you place anything on the top of the Media Receiver it will
not receive enough ventilation and will not operate properly.
NOTE
• Allow enough space around the upper and back parts when
installing to ensure adequate ventilation of the rear of the
unit.
Using the optional PIONEER stand
• For details on installation, refer to the instruction manual
supplied with the stand.
Using the optional PIONEER speakers
• For details on installation, refer to the instruction manual
supplied with the speaker.
CAUTION
Operating Environment
Operating environment temperature and humidity:
+0°C to +40°C; less than 85% RH (cooling vents not blocked)
Do not install this unit in a poorly ventilated area, or in
locations exposed to high humidity or direct sunlight (or strong
artificial light)
16
En

Installing the Media Receiver

Plasma Display
System cable
(approx. 3 m)
CAUTION
• Do not place a VCR or any other device on the top
of the Media Receiver.
• When installing, allow enough space on the sides
and above the Media Receiver.
• Do not block the side ventilation opening or the
rear exhaust opening of the Media Receiver.
ON STANDBY TIMER
STANDBY/ON
Over 5 cm
Ventilation
opening
CAUTION
Placing the Media Receiver alone in the vertical position can
result in product damage and malfunction.
Media Receiver
ON STANDBY TIMER
STANDBY/ON
Over 5 cm
PULL
OPEN
Over 5 cm
Over 10 cm
Exhaust
opening
PULL
OPEN