Publicité
Les langues disponibles
Les langues disponibles
CONTROLS AND FEATURES
4 LINE audio output terminal (2 lines)
Decodes EMBEDDED AUDIO signals and outputs them as analogue signals.
The audio channel output from the LINE audio output terminals (OUT 1 or OUT 2) is
switched according to the audio channel group selected for EMBEDDED AUDIO.
See the table below for more information.
EMBEDDED AUDIO channel group
* The AUTO setting mixes and outputs all 8 signal channels. The output level is automatically
set by detecting the number of channels the signal has.
About sound output level
Sound output level is set to a standard output level for all channels when several sound
channels are output at the same time. The more channels are selected, the lower each
channel's level will be. (Each channel's level becomes half for 1–2 ch, quarter for 1–4 ch.)
NOTES:
• When the input signal from another Input Card is selected for the monitor, the input audio signal
selected last from among the inputs on this card and the audio channel selected at that time are
output.
• No signal is output when the monitor is turned off or in stand-by mode.
5 Connection terminal (on the rear side)
Attach to the connection terminal in the slot of your Multi-format Monitor.
NOTE:
• Do not touch the dip switches near the connection terminal.
About AUDIO LEVEL METER function
Use the "STATUS DISPLAY" on the Setup Menu of the Multi-format Monitor to set AUDIO LEVEL
METER display on or off, and its various settings.
Refer to your Multi-format Monitor instruction manual for more information.
4
1 ch
2 ch
3 ch
4 ch
5 ch
6 ch
7 ch
8 ch
1–2 ch
3–4 ch
5–6 ch
7–8 ch
1–4 ch
5–8 ch
AUTO*
(continued)
OUT 1
channel 1
channel 2
channel 3
channel 4
channel 5
channel 6
channel 7
channel 8
channels 1+2
channels 3+4
channels 5+6
channels 7+8
channels 1–4
channels 5–8
channels 1–8
OUT 2
channel 2
channel 2
channel 4
channel 4
channel 6
channel 6
channel 8
channel 8
channels 1+2
channels 3+4
channels 5+6
channels 7+8
channels 1–4
channels 5–8
channels 1–8
Publicité
