Deca JOB 524 T3 LAB Manuel D'instruction page 16

Screenshot: HOME
Screenshot: Synergic MIG welding
N
308
B
Screenshot: manual MIG welding
B
Screenshot: MIG welding parameters
H
Screenshot: MMA welding
B
Screenshot: TIG welding
B
950005-00 01/03/21
A Statusbar. Indicates the main adjustments in operation.
B Measured values of welding current and voltage.
C Set values of material thickness / welding current / wire
speed. The choice of which value to display is made by
pressing the "2" knob.
D Correction of welding voltage: greater or lesser
penetration of the arc. (Knob "3").
E Wire speed on manual welding.
G Welding voltage on manual welding.
H Welding parameters bar. (Press knob "1").
I Navigation bar. (Press knob "3").
M Welding current on MMA / TIG process. (Knob "2").
N Synergic programs reference number
A
Knob "1" allows you to select the parameters present in the
C
"Welding parameters bar" and to set the desired values.
Press the knob to confi rm your choise.
Knob "3" controls the "Navigation bar". It is used to move
D
between the various views and also includes some secondary
adjustments. Press the knob to confi rm your choise.
After commissioning, switch on the welding machine, open the
A
protection gas valve.
The welding machine is ready for use with the last welding
process / program used.
E
Select the welding process
¾Press knob "3" and select the icon:
G
¾In the "HOME" view, select the desired welding process. The
welding machine is ready with the last program used.
Setting for synergic MIG welding
A
¾Press knob "1" and in the welding parameters bar select the
icon:
I
¾In the "MIG welding parameters" view, set the type of
material, the wire diameter and the type of shielding gas.
(knob "1").
¾In the "Synergic MIG welding" work view set, as per your
custom, the thickness of the material, or the welding current
or the wire speed (Knob "2").
¾The arc penetration is adjusted by knob "3".
A
In synergistic mode, all welding parameters are connected
L
to each other to facilitate the setting of the machine.
Setting for manual MIG welding
M
Also in manual MIG welding it is necessary to set the material,
L
the wire thickness and the type of shielding gas. The selection
of these parameters will help you to adjust the wire speed
and the welding voltage.
¾Press knob "1" and in the "welding parameters bar" select
A
the icon:
¾In the "MIG welding parameters" view, set the type of
material, the wire diameter and the type of shielding gas.
M
(knob "1").
¾In the "Manual MIG welding" work view, set the wire speed
(Knob "2") and welding voltage (Knob "3").
15
Browse through Views
Welding process setup