Glass Removal / Installation; Crystal Media Installation - Napoleon NEFL50HF-BT-LOWC Manuel

Masquer les pouces Voir aussi pour NEFL50HF-BT-LOWC:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

5.2

glass removal / installation

WARNING
!
Glass may be hot. Do not touch glass until cooled.
If equipped with door latches that are part of a safety system, they must be properly engaged. Do not
operate the appliance with latches disengaged.
Facing and/or fi nishing materials must not interfere with air fl ow through air openings, louvre openings,
operation of louvres, or doors/access for service. Observe all clearances when applying combustible
materials.
Before door is removed, turn the appliance off and wait until appliance is cool to the touch. Doors are heavy
and fragile so handle with care.
Remove the front surround (see "front surround removal / installation" section).
A.
Remove the four screws holding the glass retainer brackets in place, then remove the brackets and set
B.
them aside (Fig. 5-6).
Remove the glass and place it face-down on a soft,non-abrasive surface (Fig. 5-7).
C.
Reverse these steps to install the glass.
D.
5.3

crystal media installation

The front surround and glass must be removed and the appliance must be mounted in its final location before
crystals are installed (see "front surround removal / installation" section).
Clean crystal media with mild dish soap, drain, rinse thoroughly
A.
and dry before placing into the tray.
Carefully place crystals into the bottom tray on the front of the
B.
appliance as illustrated. Apply an even layer from side to side.
Resecure the glass (see "glass removal / installation" section).
C.
Resecure the front surround.
D.
Fig. 5-6
finishing
47.1
Fig. 5-7
W415-2984 / 01.13.21
EN
17

Publicité

Chapitres

Table des Matières
loading

Table des Matières