Temperature Limiting Control; Maintenance; Cleaning - Napoleon NEFL50HF-BT-LOWC Manuel

6.4

temperature limiting control

WARNING
!
• Never use batteries in fire. Failure to observe this precaution may result in an explosion. Dispose of batteries at
your local hazardous material processing center.
The heater is equipped with a temperature limiting control. Should the heater reach an unsafe temperature, the
heater will automatically turn off. To reset:
1. Unplug the power cord from the outlet.
2. Turn the power switch on the touch display panel to "OFF". Wait 5 minutes.
3. Inspect the appliance to make sure no vents are blocked or clogged with dust/lint/etc. If they are, use a
vacuum to clean the vent areas.
4. With the power switch in the "OFF" position, plug the power cord back into the outlet.
5. If the problem persists, have your outlet and wiring inspected by a professional.

7.0 maintenance

7.1

cleaning

WARNING
!
• Always turn the heater off and unplug the power cord from the outlet before cleaning, performing maintenance,
or moving this appliance. Failure to do so could result in electric chock, fire, or personal injury.
• Never immerse in water or spray with water. Doing so could result in electric shock, fire, or personal injury.
Metal:
• Buff using a soft cloth, slightly dampened with a citrus oil-based product.
• Do not use brass polish or household cleaners as these products will damage the metal trim.
Glass:
• Use a good quality cleaner sprayed onto the cloth or towel. Dry thoroughly with a paper towel or lint-free
cloth.
• Never use abrasive cleaners, liquid sprays, or any cleaner that could scratch the surface.
Vents:
• Use a vacuum or duster to remove dust and dirt from the heater and vent areas.
Plastic:
• Wipe gently with a slightly damp cloth and a mild solution of dish soap and warm water.
• Never use abrasive cleaners, liquid sprays, or any cleaner that could scratch the surface.
operating instructions
W415-2984 / 01.13.21
EN
21